新闻动态
安装通风设备要注意的问题?
安装通风设备要注意的问题?
What should be paid attention to when installing ventilation equipment?
1.施工人员在作业中遵守有关国家的法律法规以及企业的劳动纪律,安全帽要到位,禁止拖鞋、赤背、吸烟、打闹、酒后作业等一系列违反操作的事项;
1. Construction personnel shall comply with relevant national laws and regulations as well as the labor discipline of the enterprise during the operation, with safety helmets in place, and a series of violations such as slippers, bare backs, smoking, fighting, and drunk work are prohibited;
2.在吊装前要检查好所有的设备的完好度,确定没问题再作业,吊装的指挥员以及旁边的监护人员都不可缺少;
2. Before lifting, it is necessary to check the integrity of all equipment and ensure that there are no problems before starting the operation. The lifting commander and nearby monitoring personnel are indispensable;
3.设备距离安装地较远,运输途中注意安全,严禁有人。
3. The equipment is far away from the installation site, so be careful during transportation and no one is allowed.
近年来,跟着人们生活水平的不断进步,人们的健康知道越来越高,通风设备走进了办公大楼,成为人们日常生活中必不可少的一部分。通风设备的热卖推动了通风设备技术的开展,使得通风设备的设备技术越来越好。可是,不可防止的,通风管道在设备时会出现破损问题,接下来说明怎样应对通风管道破损问题。
In recent years, with the continuous improvement of people's living standards, people's health awareness has become increasingly high. Ventilation equipment has entered office buildings and become an essential part of people's daily lives. The popularity of ventilation equipment has promoted the development of ventilation equipment technology, making the equipment technology of ventilation equipment increasingly better. However, it is inevitable that ventilation ducts may be damaged during equipment operation. Next, we will explain how to deal with the problem of ventilation duct damage.
如果在通风管道外就用专用的密封胶就可以修补,管道表面面的铝箔层发生破损,而玻纤保温层未发生损坏,则可选用一片合格的铝箔片进行管道铝箔表面的修补。
If a special sealant is used outside the ventilation duct to repair it, and the aluminum foil layer on the surface of the duct is damaged, but the glass fiber insulation layer is not damaged, a qualified aluminum foil sheet can be selected for the repair of the aluminum foil surface of the duct.
如果在通风设备设备时发现破损已达到玻纤保温层时,则可将破损的当地切开下来,另选一块无缺的板材,根据切开下来的玻板标准切开好,然后泥杆 保定古筝 塑料增韧剂 拱形护坡模具 保定空调维修  托辊生产线在四周接口上涂上修补胶及粘胶剂,根据工艺标准进行密封,在通风设备正常作业时就要常常检查防止耽搁作业。
If it is found that the damage to the ventilation equipment has reached the glass fiber insulation layer, the damaged area can be cut off, and another intact board can be selected. According to the standard of the cut glass board, it can be cut off, and then repair glue and adhesive can be applied to the surrounding interfaces. Sealing should be carried out according to the process standards. During normal operation of the ventilation equipment, frequent inspections should be carried out to prevent delays in operation.

版权 © 保定市清鑫管道加工厂 网址:www.guandaojiagong.cn  推荐:保定通风管道,保定厨房排烟,保定螺旋风管

全自动软水器 保定洗地机 保定电动门 钢纤维 成都地暖 流水槽模具 网站建设及优化保定遨游网络公司